Make your existing night light ready for sliders


Here’s how to convert your existing custom photo night light to work with Sliders.

Disassemble the night light

  1. Carefully remove the light base by holding the frame in one hand while gently twisting and pulling the light base until it is removed.
  2. Remove the tab that covers the other orientation slot and set it aside.
  3. With the frame facing you press both thumbs on your photo until you hear a clicking sound.
  4. Now you can remove the front shield, the rear shield and your photo from the frame.

Now you’re ready to put the night light back together.

  1. Decide if you want to use the night light in Portrait or Landscape mode.
  2. Insert the front shield into the frame. It’s the thinner pliable plastic piece.
  3. Insert the rear shield into the frame. Take a moment to notice there is a raised ridge on the sides that should face downward when you insert the rear shield into the frame. The rear shield should snap firmly into place.
  4. Insert the tab cover into the orientation slot you are not using.
  5. Place the frame on a flat surface and re-insert the light base into the frame. Gently pressing and twisting at the same time until it snaps into place.
  6. Now you are ready to insert your sliders. Pick your favorite slider and enjoy.